Dynisco PT462E-G3-50MPA standard type melt pressure sensors

Dynisco PT462E standard type melt pressure sensors are devices used to measure melt pressure, commonly used in industrial fields such as plastic extrusion and injection molding. The following is a related introduction:

Pressure measurement range: Similar to the same series of products, the pressure range may be around 0 - 500PSI to 0 - 10,000PSI, please refer to the product manual for details. For example, there is a PT462E - G3 - 50MPA model, indicating that it can measure a maximum pressure of 50MPa.

Accuracy: Usually has a high accuracy, the accuracy may be better than ±0.5%, can provide more accurate pressure data for the production process, help to accurately control the production process, and ensure product quality stability.

Output signal: It may have a full-scale output signal of 3.33mV/V, which is convenient for connection with subsequent signal processing equipment such as data acquisition systems and controllers to realize the monitoring and control of melt pressure.

Structural design and material: The rigid rod structure is easy to install and can be quickly installed on the melt flow channel of extruders, injection molding machines and other equipment. The sensor diaphragm may use the patented DyMax coating, which has wear and corrosion resistance. It can maintain good stability and repeatability in harsh environments such as high temperature and high viscosity melts. It can work stably for a long time, reduce measurement errors, and extend service life.

Application areas: Dynisco is a leading manufacturer of melt pressure and temperature monitoring sensors. Its PT462E standard melt pressure sensor can be used in plastic extrusion, oil services, food and medicine, injection molding, blow molding and resin production. It can provide important pressure parameter support for production process optimization and control.

Common models Dynisco PT462E standard melt pressure sensor

Dynisco PT462E standard melt pressure sensor has a variety of models, the following are some of the common ones:

PT462E-G3-50MPA: From the model, it can be known that it can measure pressures up to 50MPa, and may have a full-scale output signal of 3.33mV/V, which is suitable for melt measurement scenarios with high pressure requirements.

PT462E-1.4MB-6/18: The pressure range is - 1.4MB - 0 - 1400PSI, with an accuracy better than ±0.5%, using a 6-inch rigid rod and 18-inch flexible capillary, which is easy to install and suitable for local high temperature environments.

PT462E-XM-6/18: It has a 3.33mV/V output signal, an accuracy of ±0.5%, is equipped with a 6-pin connector, and can be optionally equipped with a thermocouple or RTD configuration to provide melt temperature, and the mounting thread is 1/2 - 20 UNF.

PT462E-10-6M8: uses a 6mm sensing diaphragm, a full-scale output of 3.33mV/V, an accuracy better than ±1%, a pressure range of 0 - 5000PSI to 0 - 10000PSI, and good stability and repeatability.

PT462E-M10: uses a 6mm sensing element, suitable for space-constrained areas such as small extruders and rheometers, equipped with an 18-inch flexible rod to isolate the electronic housing from the high-temperature process environment, and a pressure range of 0 - 5000PSI to 0 - 10000PSI.

PT462E-7.5C-9/18: It is a classic flexible rod melt pressure sensor. The detailed parameters such as the specific pressure range have not been fully announced, but it should have the general characteristics of this series of sensors, such as high accuracy and good corrosion resistance.

PT462E-3M-6/18: can be used to measure melt pressure. It has the typical output signal characteristics and accuracy level of this series of products. Please refer to the product manual for the specific pressure range. 6/18 may represent its related dimensional parameters such as its rod length.