SMC CXSM32-75 double cylinder Dual Rod Cylinder

SMC CXSM32-75 CXS series cylinders are a double rod, double acting cylinder with guide rods produced by SMC company. The following is a detailed introduction about it:

Basic parameters

Cylinder diameter: 32mm, which means the inner diameter of the cylinder is 32mm, determining the output force of the cylinder.

Travel: 75mm, refers to the distance that the cylinder piston can move, which is 75mm.

Action mode: Double acting, that is, the piston of the cylinder can move in two directions, achieved by alternately inputting compressed air into the two chambers of the cylinder.

Speed: The piston speed is usually between 30-600mm/s, and can be controlled by adjusting the intake flow rate and other methods according to actual application needs.

Working pressure range: The minimum working pressure is 0.05MPa, the maximum working pressure is 0.7MPa, and the pressure test pressure is 1.05MPa.

Fluid used: Air (without oil), using clean, dry compressed air as a power source, without the need for additional lubricating oil.

Environment and fluid temperature: The working environment temperature and fluid temperature range are -10 ℃ to 60 ℃, but attention should be paid to avoiding fluid freezing.

Structural characteristics

Built in magnet: convenient for installing magnetic switches, used to detect the position of the piston, thereby achieving precise control of cylinder movement, can feedback the working status of the cylinder, and provide signals for the automation control system.

Guidance function: CXSM slide bearing is used for guidance, equipped with guide rods and sliding bearings, with high-precision guidance performance, which can effectively prevent the piston rod from swinging or rotating during movement, ensuring the straightness and stability of cylinder movement, suitable for occasions requiring precise position control.

Rubber buffer: A rubber buffer device is installed at the end of the stroke of the cylinder, which can reduce the impact force of the piston when it reaches the end of the stroke, reduce mechanical wear and noise, and extend the service life of the cylinder.

Multi directional installation: It can be installed from 3 directions, and the working components can be installed on 3 surfaces, increasing the flexibility and convenience of installation, making it easy to use in different equipment and working conditions.