GE Fanuc Emerson Field Control distributed I/O IC670CBL002

The GE Fanuc IC670CBL002 Base Connection Cable comes pre-assembled from the factory, with keyed connectors designed to make an erroneous connection impossible. It can be used to interconnect 2 GE Fanuc Terminal Blocks to one another or a single GE Fanuc Terminal Block to its corresponding BIU (Bus Interface Unit). The GE Fanuc IC670CBL002 Base Connection Cable comes with a braided ground wire which is meant to be used as an ESD protection measure. This cable must be connected to zero voltage at both ends (ground or chassis) to provide effective immunity against electrical interference or external noise. This 21-inch expansion cable should be installed so as not to interrupt the flow of data between modules and to respect the connection polarity of each of the bases. If the cable is connected to the top connector of one base, then it should be plugged into the bottom connector of the next base.

Technical specifications for IC670CBL002

Brand GE Fanuc

Series Field Control

Part Number IC670CBL002

Type of Component Expansion connection cable

ESD Protection Braided drain wire connected to ground or chassis

Length in Centimeters 54.61

Length in Inches 21

Protected Against Misconnections Yes, using keyed connectors

Devices it can Interconnect With Terminal block to terminal block, terminal block to BIU

Number of Cables per Field Control Station 1

IC670CBL002A,IC670CBL002-A, Series A, Rev A