NOTIFIER J-XAP-M-M500HC NFS2-3030 series fire alarm control panels

The NOTIFIER J-XAP-M-M500HC is a smart fire hydrant button designed for indoor fire - fighting systems. Here is an introduction:

General Description

The J-XAP-M-M500HC is an addressable device in the fire - control system. It is installed on indoor fire hydrants and is used to manually start the fire - fighting water pump on - site and display the running status of the pump.

Features

Embedded Installation: It is embedded and installed in a standard 76×76mm pre - embedded box with a horizontal mounting hole spacing of 60mm.

Low - Voltage and Low - Current Operation: It operates at a rated voltage of 24VDC, with a static current of 200μA and an alarm current of 5mA (LED rated value is 30mA).

Fire - fighting Pump Control: It can directly start the fire - fighting water pump and receive feedback information from the pump room. When the LED on the button lights up, it indicates that the pump is running.

Simple Structure and Easy Installation: With a simple structure, it is easy to install, reliable in operation, and can significantly reduce project costs, facilitating the selection and construction of supporting equipment.

Intelligent Addressing: It can be incorporated into a two - bus alarm control system. Each button has a unique address, allowing the controller to accurately identify the location of the alarm.

Application Scenarios

This button is suitable for normal indoor environments, such as office buildings, hotels, schools, hospitals, and other places equipped with indoor fire hydrants. However, it is not suitable for outdoor or hazardous environments.

Technical Specifications

In addition to the above - mentioned power supply and installation dimensions, its protection level is IP65, and it complies with the standard GB19880 - 2005. When the button is pressed, it can quickly send out an alarm signal, and the controller can receive and display the alarm address within a short time.